Leather Triple Wrap X Bracelet

Download Printable Version (PDF)

Products needed to make the bracelet
1m 5x2mm flat liquorice leather cord distressed pastel turquoise (LF05PT)
2 x 10x10mm ant copper X slider for flat leather (BAR45AC)
1 x 9mm ant copper folk flower square slider (BAR235AC)
1 x 5mm dots magnetic clasp for flat leather (LMAG21AC)
6 x 7.25mm rubber o-rings sage green (ROR7-25-23)
6 x 7.25mm rubber o-rings marine teal (ROR-25-48)

Tools needed to complete the bracelet
Glue – we prefer E6000 or Aleenes’ Jewelry & Metal Glue
Leather cutters or sharp scissors

Instructions to complete the Turquoise Leather Triple Wrap Bracelet

Step 1
Measure the size of your wrist. You can use our bracelet sizing chart as a guide for a good fit. Then triple your measurement and allow a little extra, you can always trim off the excess later. Cut your leather to the desired length.

Step 2
On one end of the leather, trim to create an angle as shown in our picture. This will make it easier to slide on the o-rings and the copper sliders.
On our bracelet we have positioned one X slider and o-rings 10cm from the end, the square slider and o-rings in the centre of the bracelet and the other X slider and o-rings 10cm at the opposite end of the leather. You can always adjust these later.

Step 3
Glue one end of the clasp to the leather and leave to dry.
Re-try the bracelet on for size and trim off any excess leather if needed.
Glue the other end of the clasp to the leather and leave to dry.
Move the sliders and O-rings along the leather if needed to create a nice pattern.

You have now made yourself a gorgeous Turquoise leather triple wrap bracelet!

© 2017 Over the Rainbow. This project may be used for personal use & for reselling of completed item however the printed instructions & images may not be used in classes without prior permission.

Download these instructions (PDF)