Leather & Copper Focal Bracelet

Download Printable Version (PDF)

Products needed to make the bracelet
25cm x Flat 2mm x 10mm flat Bark Licorice leather – Taupe Brown (FL-BK10-2)
1 x 10x2mm ID Antique Copper flat leather rounded magnetic clasp (LMAG18AC)
1 x 10x2mm flat leather Antique Copper Feather Slider (BAR174AC)

Tools needed to complete the bracelet
Glue – we prefer E6000 or Aleenes’ Jewelry & Metal glue
Leather cutter or sharp scissors

Instructions to complete the Leather and Copper Feather Bracelet

Step 1
Measure the size of your wrist. You can use our bracelet sizing chart as a guide for a good fit. Cut your leather to the correct length, allow a little extra. You can always trim this of before the final gluing of the clasp.

Step 2
Slide the copper feather slider onto the leather, and glue one end of the clasp to the leather. Leave to dry.

Step 3
Retry the bracelet on for size and trim off any excess leather if needed. Glue the other end of the clasp to the leather and leave to dry.
Position the copper feather slider in the centre of the bracelet. You have now made your Leather and copper feather bracelet!

© 2017 Over the Rainbow. This project may be used for personal use & for reselling of completed item however the printed instructions & images may not be used in classes without prior permission.

Download these instructions (PDF)